MetalworkingFun Forum › Machining › General Metalworking Discussion v
Keyway Bushing

Thread Modes
Keyway Bushing
Highpower Offline
JAFO
******
Posts: 4,452
Threads: 184
Joined: Feb 2012
Location: Missouri, USA
#9
04-07-2012, 06:42 PM (This post was last modified: 04-07-2012, 06:51 PM by Highpower.)
Just let me go on record as suggesting to slather the entire broach with oil, and not just the cutting teeth.
Also clear the chips out of the teeth before making another pass if it needs more than one.

But that's just me... Smiley-gen163

In the next few days I'll post some pics of what NOT to do.... Smiley-signs125

BashBashBash
Willie
Reply
Thanks given by:


Messages In This Thread
Keyway Bushing - by aametalmaster - 04-07-2012, 10:47 AM
RE: Keyway Bushing - by Highpower - 04-07-2012, 10:58 AM
RE: Keyway Bushing - by EdK - 04-07-2012, 11:50 AM
RE: Keyway Bushing - by DaveH - 04-07-2012, 11:55 AM
RE: Keyway Bushing - by Highpower - 04-07-2012, 06:01 PM
RE: Keyway Bushing - by stevec - 04-07-2012, 05:12 PM
RE: Keyway Bushing - by DaveH - 04-07-2012, 06:12 PM
RE: Keyway Bushing - by aametalmaster - 04-07-2012, 06:25 PM
RE: Keyway Bushing - by Highpower - 04-07-2012, 06:42 PM
RE: Keyway Bushing - by PixMan - 04-08-2012, 10:04 AM
RE: Keyway Bushing - by aametalmaster - 04-08-2012, 10:20 AM
RE: Keyway Bushing - by Highpower - 04-08-2012, 05:11 PM
RE: Keyway Bushing - by aametalmaster - 04-08-2012, 07:22 PM
RE: Keyway Bushing - by Highpower - 04-08-2012, 09:34 PM
RE: Keyway Bushing - by aametalmaster - 04-09-2012, 03:44 AM



Users browsing this thread: 2 Guest(s)