06-10-2013, 07:04 AM
Well, there's really no clear lines between brass/copper/zinc alloys. There's a million of them.
I don't think I'll be able to use one of those. The Alliant mill has a long hex draw bar. While that allows you to change tools without fully retracting the quill, it means less clearance on top when you DO retract it.
I don't think I'll be able to use one of those. The Alliant mill has a long hex draw bar. While that allows you to change tools without fully retracting the quill, it means less clearance on top when you DO retract it.