06-05-2013, 09:09 AM
It's really a very simple process. We used this method both on my Lagun and my W&S turret lathe.
Raise the pallet jack a few inches.....literally.
Block up some wood or aluminum or steel blocks under the base and lower the pallet truck.
Remove the pallet truck from under the machine.
Use a long pry bar (I have one we can use) and lift one side to replace the blocks under it with smaller ones....a couple inches or so.
Settle the machine on the blocks and go to opposite side and repeat process.
It should only take you maybe three times on each side to get it on the floor.
You're done.....time for a beer!
See.....piece of cake!!
Later,
Russ
Raise the pallet jack a few inches.....literally.
Block up some wood or aluminum or steel blocks under the base and lower the pallet truck.
Remove the pallet truck from under the machine.
Use a long pry bar (I have one we can use) and lift one side to replace the blocks under it with smaller ones....a couple inches or so.
Settle the machine on the blocks and go to opposite side and repeat process.
It should only take you maybe three times on each side to get it on the floor.
You're done.....time for a beer!
See.....piece of cake!!
Later,
Russ