06-05-2013, 08:21 AM
Ken, are the four holes in the base threaded? If so, after hacking, cutting (or burning?
) the wood away I would use some allthread rod, nuts and washers to lift the mill enough to extricate the rest of the "pallet" then position the mill with the pallet truck and replace the the threaded rods with some good quality leveling feet and be done with it.
Now to get it wired up and running!
) the wood away I would use some allthread rod, nuts and washers to lift the mill enough to extricate the rest of the "pallet" then position the mill with the pallet truck and replace the the threaded rods with some good quality leveling feet and be done with it.Now to get it wired up and running!
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.