Use the force Luke!
If it were me, I would remove the side panels and blocks from the plywood base and then lower it down as far as it will go. A big arse pry bar should be able to slide it off. You may need to 'step down' with some small blocks until you can get it down onto the floor. Of course, you would want some people there to assist...
I made a toe jack to lift my mill on/off the pipe rollers. Easy to make if you have a bottle jack, some scrap steel and a welder.
Or - tell Russ that he can only have the pallet jack if he comes and removes it (placing the mill level on the floor in the process)
If it were me, I would remove the side panels and blocks from the plywood base and then lower it down as far as it will go. A big arse pry bar should be able to slide it off. You may need to 'step down' with some small blocks until you can get it down onto the floor. Of course, you would want some people there to assist...
I made a toe jack to lift my mill on/off the pipe rollers. Easy to make if you have a bottle jack, some scrap steel and a welder.
Or - tell Russ that he can only have the pallet jack if he comes and removes it (placing the mill level on the floor in the process)
Hunting American dentists since 2015.