Dallen, I had to look for the "taper" , I found it on the threaded side of the knurled "knob".
As far as I can see it's going to be a puller of very distinct length. I have a couple of pullers that use the taper idea to close the jaws but the pressure screw threads into the tapered "jaw tightening " screw.
I notice a hole in the end of your screw, will that be for the puller (pressure) screw or just for a pointed "pilot" center?
I'm going to the shop right now to check on my feeble , beer addled mind.
As far as I can see it's going to be a puller of very distinct length. I have a couple of pullers that use the taper idea to close the jaws but the pressure screw threads into the tapered "jaw tightening " screw.
I notice a hole in the end of your screw, will that be for the puller (pressure) screw or just for a pointed "pilot" center?
I'm going to the shop right now to check on my feeble , beer addled mind.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.