An Engine by 3 Amigo's

[krv3000]

thanks all last bit was to cut two slots in the brass tube at the top for filing it up then made a plastic plug to go in just below the slots you will see in the pic the next bit you will need a old car bulb ? you will see that in the pic to this is to mack the caps i made the filer 5.8 OD with 4.8 inside with a m3 thread this will screw on the top then made the cap by using the brass base of the bulb to press the cap from removed the working bit of the bulb then removed the bottom on me sander then split the base cut off the bend from the top then got it hot then straited it out cleaned the brass up got it hot a gane then with a dowel with a 5.5 mm DI and a bush with a internal of 6 mm i put the brass over the hole then give it a smack with me hammer lol you don't need to hit it hard once the shape was made SOS no pic of this bit but i stuck the cap on the bottom of a old AAA battery to file the wast a way to Lev the cap then i soldered a spring in to the cap that then screws on to the top of the tube ha presto one oil filer cap the pics will explain more