MetalworkingFun Forum › Machinery › Lathes › Lathe Tooling v
New Dorian AXA QCTP

Thread Modes
New Dorian AXA QCTP
the penguin Offline
Junior
****
Posts: 482
Threads: 89
Joined: Oct 2012
Location: camillus (syracuse), ny
#6
05-19-2013, 09:31 AM
In the first picture (reshown below) the piece sticking out of the lathe chuck, is a Jancy mag drill 4" long center pin. The pin is hardened and has a ground point, that what I use to set the cutting edge height, quick and easy.


Attached Files Thumbnail(s)
   
jack
Reply
Thanks given by:


Messages In This Thread
New Dorian AXA QCTP - by the penguin - 05-18-2013, 09:16 PM
RE: New Dorian AXA QCTP - by EdK - 05-18-2013, 09:33 PM
RE: New Dorian AXA QCTP - by stevec - 05-19-2013, 06:46 AM
RE: New Dorian AXA QCTP - by Highpower - 05-19-2013, 08:41 AM
RE: New Dorian AXA QCTP - by the penguin - 05-19-2013, 09:01 AM
RE: New Dorian AXA QCTP - by the penguin - 05-19-2013, 09:31 AM
RE: New Dorian AXA QCTP - by stevec - 05-19-2013, 11:22 AM
RE: New Dorian AXA QCTP - by the penguin - 05-19-2013, 11:29 AM
RE: New Dorian AXA QCTP - by stevec - 05-19-2013, 03:18 PM
RE: New Dorian AXA QCTP - by PixMan - 05-25-2013, 08:43 PM
RE: New Dorian AXA QCTP - by the penguin - 05-26-2013, 11:09 PM
RE: New Dorian AXA QCTP - by Mayhem - 05-25-2013, 11:27 PM
RE: New Dorian AXA QCTP - by the penguin - 06-10-2013, 05:13 PM



Users browsing this thread: 5 Guest(s)