05-14-2013, 08:56 PM
That's one for the library. Nice work.
If you don't have a spin indexer, you could make up a frame with a tooth that uses the original gear teeth as the index. If you made it adjustable vertically, you could test it on successive good teeth before moving in to cut the new ones.
If you don't have a spin indexer, you could make up a frame with a tooth that uses the original gear teeth as the index. If you made it adjustable vertically, you could test it on successive good teeth before moving in to cut the new ones.
Mike
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.