Hole Sizes for Reaming

Hello There, Guest! Register

Thread Modes

Hole Sizes for Reaming

Highpower Offline

Offline

JAFO

Posts: 4,460
Threads: 184
Joined: Feb 2012
Location: Missouri, USA

#19

05-08-2013, 08:55 AM

(05-08-2013, 08:05 AM)Mayhem Wrote: Sorry Willie - I misunderstood your post.

No problem mate. They say the written word is one of the poorest forms of communication. Especially if I'm the one writing it.... Big Grin

Big Grin

I have one of these pieces of junk from SPI.
[Image: SPU-13967.jpg]

[Image: SPU-13967.jpg]

The scale is pinned to the sliding barrel. It would have been nice if they had the scale at the proper angle before they pinned it. It's not flush with the rule edge. The corners on the scale are rounded off and the graduations are wide and blurry. Angry

Angry

One of those regrettable purchases.

Smiley-signs125

Willie

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Hole Sizes for Reaming - by EdK - 05-05-2013, 02:12 PM

RE: Hole Sizes for Reaming - by doubleboost - 05-05-2013, 02:59 PM

RE: Hole Sizes for Reaming - by EdK - 05-05-2013, 03:10 PM

RE: Hole Sizes for Reaming - by doubleboost - 05-05-2013, 03:12 PM

RE: Hole Sizes for Reaming - by wrustle - 05-05-2013, 03:28 PM

RE: Hole Sizes for Reaming - by f350ca - 05-05-2013, 07:09 PM

RE: Hole Sizes for Reaming - by EdK - 05-06-2013, 05:52 AM

RE: Hole Sizes for Reaming - by f350ca - 05-06-2013, 08:29 AM

RE: Hole Sizes for Reaming - by Highpower - 05-06-2013, 10:54 AM

RE: Hole Sizes for Reaming - by f350ca - 05-06-2013, 11:11 AM

RE: Hole Sizes for Reaming - by Highpower - 05-06-2013, 12:48 PM

RE: Hole Sizes for Reaming - by stevec - 05-06-2013, 03:29 PM

RE: Hole Sizes for Reaming - by f350ca - 05-06-2013, 06:35 PM

RE: Hole Sizes for Reaming - by stevec - 05-07-2013, 05:51 AM

RE: Hole Sizes for Reaming - by Highpower - 05-07-2013, 08:11 AM

RE: Hole Sizes for Reaming - by Mayhem - 05-07-2013, 09:46 AM

RE: Hole Sizes for Reaming - by Highpower - 05-07-2013, 08:00 PM

RE: Hole Sizes for Reaming - by Mayhem - 05-08-2013, 08:05 AM

RE: Hole Sizes for Reaming - by Highpower - 05-08-2013, 08:55 AM

RE: Hole Sizes for Reaming - by f350ca - 05-08-2013, 11:49 AM

RE: Hole Sizes for Reaming - by Highpower - 05-08-2013, 08:59 PM

Users browsing this thread: 2 Guest(s)