|
Hole Sizes for Reaming
|
05-06-2013, 10:54 AM
Even with a Drill Doctor (I have one too) you can still end up grinding more off of one flute than the other. Most of us don't have eagle eye vision anymore
 and still need measure the length of the cutting lips to make sure they are equal, otherwise it's going to drill an over-sized hole. 
Willie
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Hole Sizes for Reaming - by EdK - 05-05-2013, 02:12 PM
RE: Hole Sizes for Reaming - by doubleboost - 05-05-2013, 02:59 PM
RE: Hole Sizes for Reaming - by EdK - 05-05-2013, 03:10 PM
RE: Hole Sizes for Reaming - by doubleboost - 05-05-2013, 03:12 PM
RE: Hole Sizes for Reaming - by wrustle - 05-05-2013, 03:28 PM
RE: Hole Sizes for Reaming - by f350ca - 05-05-2013, 07:09 PM
RE: Hole Sizes for Reaming - by EdK - 05-06-2013, 05:52 AM
RE: Hole Sizes for Reaming - by f350ca - 05-06-2013, 08:29 AM
RE: Hole Sizes for Reaming - by Highpower - 05-06-2013, 10:54 AM
RE: Hole Sizes for Reaming - by f350ca - 05-06-2013, 11:11 AM
RE: Hole Sizes for Reaming - by Highpower - 05-06-2013, 12:48 PM
RE: Hole Sizes for Reaming - by stevec - 05-06-2013, 03:29 PM
RE: Hole Sizes for Reaming - by f350ca - 05-06-2013, 06:35 PM
RE: Hole Sizes for Reaming - by stevec - 05-07-2013, 05:51 AM
RE: Hole Sizes for Reaming - by Highpower - 05-07-2013, 08:11 AM
RE: Hole Sizes for Reaming - by Mayhem - 05-07-2013, 09:46 AM
RE: Hole Sizes for Reaming - by Highpower - 05-07-2013, 08:00 PM
RE: Hole Sizes for Reaming - by Mayhem - 05-08-2013, 08:05 AM
RE: Hole Sizes for Reaming - by Highpower - 05-08-2013, 08:55 AM
RE: Hole Sizes for Reaming - by f350ca - 05-08-2013, 11:49 AM
RE: Hole Sizes for Reaming - by Highpower - 05-08-2013, 08:59 PM
|
