MetalworkingFun Forum › Machining › General Metalworking Discussion v
Hole Sizes for Reaming

Thread Modes
Hole Sizes for Reaming
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
#6
05-05-2013, 07:09 PM
All of the above but if you sharpen your drill bits by hand make sure they aren't cutting oversize. 1/64 is perfect for reaming but 1/64 over size if the bit faces aren't even isn't impossible.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Hole Sizes for Reaming - by EdK - 05-05-2013, 02:12 PM
RE: Hole Sizes for Reaming - by doubleboost - 05-05-2013, 02:59 PM
RE: Hole Sizes for Reaming - by EdK - 05-05-2013, 03:10 PM
RE: Hole Sizes for Reaming - by doubleboost - 05-05-2013, 03:12 PM
RE: Hole Sizes for Reaming - by wrustle - 05-05-2013, 03:28 PM
RE: Hole Sizes for Reaming - by f350ca - 05-05-2013, 07:09 PM
RE: Hole Sizes for Reaming - by EdK - 05-06-2013, 05:52 AM
RE: Hole Sizes for Reaming - by f350ca - 05-06-2013, 08:29 AM
RE: Hole Sizes for Reaming - by Highpower - 05-06-2013, 10:54 AM
RE: Hole Sizes for Reaming - by f350ca - 05-06-2013, 11:11 AM
RE: Hole Sizes for Reaming - by Highpower - 05-06-2013, 12:48 PM
RE: Hole Sizes for Reaming - by stevec - 05-06-2013, 03:29 PM
RE: Hole Sizes for Reaming - by f350ca - 05-06-2013, 06:35 PM
RE: Hole Sizes for Reaming - by stevec - 05-07-2013, 05:51 AM
RE: Hole Sizes for Reaming - by Highpower - 05-07-2013, 08:11 AM
RE: Hole Sizes for Reaming - by Mayhem - 05-07-2013, 09:46 AM
RE: Hole Sizes for Reaming - by Highpower - 05-07-2013, 08:00 PM
RE: Hole Sizes for Reaming - by Mayhem - 05-08-2013, 08:05 AM
RE: Hole Sizes for Reaming - by Highpower - 05-08-2013, 08:55 AM
RE: Hole Sizes for Reaming - by f350ca - 05-08-2013, 11:49 AM
RE: Hole Sizes for Reaming - by Highpower - 05-08-2013, 08:59 PM



Users browsing this thread: 6 Guest(s)