|
Hole Sizes for Reaming
|
05-05-2013, 02:59 PM
(05-05-2013, 02:12 PM)EdK Wrote: I need to ream some 1/2" and 3/8" holes in some 12L14 and was wondering if 1/64" undersize is the correct size for reaming? I haven't done a lot of reaming so I'm deficient in reaming knowledge. Hi Ed That should be fine I use 0.2 mm undersize Never turn the reamer in the wrong direction (but you will already know that) John Thanks given by: EdK
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Hole Sizes for Reaming - by EdK - 05-05-2013, 02:12 PM
RE: Hole Sizes for Reaming - by doubleboost - 05-05-2013, 02:59 PM
RE: Hole Sizes for Reaming - by EdK - 05-05-2013, 03:10 PM
RE: Hole Sizes for Reaming - by doubleboost - 05-05-2013, 03:12 PM
RE: Hole Sizes for Reaming - by wrustle - 05-05-2013, 03:28 PM
RE: Hole Sizes for Reaming - by f350ca - 05-05-2013, 07:09 PM
RE: Hole Sizes for Reaming - by EdK - 05-06-2013, 05:52 AM
RE: Hole Sizes for Reaming - by f350ca - 05-06-2013, 08:29 AM
RE: Hole Sizes for Reaming - by Highpower - 05-06-2013, 10:54 AM
RE: Hole Sizes for Reaming - by f350ca - 05-06-2013, 11:11 AM
RE: Hole Sizes for Reaming - by Highpower - 05-06-2013, 12:48 PM
RE: Hole Sizes for Reaming - by stevec - 05-06-2013, 03:29 PM
RE: Hole Sizes for Reaming - by f350ca - 05-06-2013, 06:35 PM
RE: Hole Sizes for Reaming - by stevec - 05-07-2013, 05:51 AM
RE: Hole Sizes for Reaming - by Highpower - 05-07-2013, 08:11 AM
RE: Hole Sizes for Reaming - by Mayhem - 05-07-2013, 09:46 AM
RE: Hole Sizes for Reaming - by Highpower - 05-07-2013, 08:00 PM
RE: Hole Sizes for Reaming - by Mayhem - 05-08-2013, 08:05 AM
RE: Hole Sizes for Reaming - by Highpower - 05-08-2013, 08:55 AM
RE: Hole Sizes for Reaming - by f350ca - 05-08-2013, 11:49 AM
RE: Hole Sizes for Reaming - by Highpower - 05-08-2013, 08:59 PM
|
