The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
Hole Sizes for Reaming

Thread Modes
Hole Sizes for Reaming
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#1
05-05-2013, 02:12 PM
I need to ream some 1/2" and 3/8" holes in some 12L14 and was wondering if 1/64" undersize is the correct size for reaming? I haven't done a lot of reaming so I'm deficient in reaming knowledge.

Thanks,
Ed
Reply
Thanks given by:


Messages In This Thread
Hole Sizes for Reaming - by EdK - 05-05-2013, 02:12 PM
RE: Hole Sizes for Reaming - by doubleboost - 05-05-2013, 02:59 PM
RE: Hole Sizes for Reaming - by EdK - 05-05-2013, 03:10 PM
RE: Hole Sizes for Reaming - by doubleboost - 05-05-2013, 03:12 PM
RE: Hole Sizes for Reaming - by wrustle - 05-05-2013, 03:28 PM
RE: Hole Sizes for Reaming - by f350ca - 05-05-2013, 07:09 PM
RE: Hole Sizes for Reaming - by EdK - 05-06-2013, 05:52 AM
RE: Hole Sizes for Reaming - by f350ca - 05-06-2013, 08:29 AM
RE: Hole Sizes for Reaming - by Highpower - 05-06-2013, 10:54 AM
RE: Hole Sizes for Reaming - by f350ca - 05-06-2013, 11:11 AM
RE: Hole Sizes for Reaming - by Highpower - 05-06-2013, 12:48 PM
RE: Hole Sizes for Reaming - by stevec - 05-06-2013, 03:29 PM
RE: Hole Sizes for Reaming - by f350ca - 05-06-2013, 06:35 PM
RE: Hole Sizes for Reaming - by stevec - 05-07-2013, 05:51 AM
RE: Hole Sizes for Reaming - by Highpower - 05-07-2013, 08:11 AM
RE: Hole Sizes for Reaming - by Mayhem - 05-07-2013, 09:46 AM
RE: Hole Sizes for Reaming - by Highpower - 05-07-2013, 08:00 PM
RE: Hole Sizes for Reaming - by Mayhem - 05-08-2013, 08:05 AM
RE: Hole Sizes for Reaming - by Highpower - 05-08-2013, 08:55 AM
RE: Hole Sizes for Reaming - by f350ca - 05-08-2013, 11:49 AM
RE: Hole Sizes for Reaming - by Highpower - 05-08-2013, 08:59 PM



Users browsing this thread: 1 Guest(s)