MetalworkingFun Forum › Machining › General Metalworking Discussion v
Cleaning Tools ...

Thread Modes
Cleaning Tools ...
mikecwik Offline
Sophmore
***
Posts: 126
Threads: 23
Joined: Apr 2012
Location: houston pa
#11
04-05-2012, 08:31 PM
i use 3in1 oil generously on the micrometers. i had a barrel freeze up on me that i still have not freed up. i rotate them every once in a while if need be or not now too.
mikecwik, proud to be a member of MetalworkingFun Forum since Apr 2012.
Reply
Thanks given by:


Messages In This Thread
Cleaning Tools ... - by arvidj - 02-25-2012, 11:37 AM
RE: Cleaning Tools ... - by stevec - 02-25-2012, 03:38 PM
RE: Cleaning Tools ... - by DaveH - 02-25-2012, 03:46 PM
RE: Cleaning Tools ... - by EdK - 02-25-2012, 03:55 PM
RE: Cleaning Tools ... - by krv3000 - 02-25-2012, 04:43 PM
RE: Cleaning Tools ... - by DaveH - 02-25-2012, 04:47 PM
RE: Cleaning Tools ... - by stevec - 02-25-2012, 07:09 PM
RE: Cleaning Tools ... - by DaveH - 02-25-2012, 07:27 PM
RE: Cleaning Tools ... - by PixMan - 02-25-2012, 07:58 PM
RE: Cleaning Tools ... - by krv3000 - 02-28-2012, 06:48 AM
RE: Cleaning Tools ... - by mikecwik - 04-05-2012, 08:31 PM
RE: Cleaning Tools ... - by arvidj - 05-01-2012, 09:20 AM
RE: Cleaning Tools ... - by EdK - 05-01-2012, 09:35 AM
RE: Cleaning Tools ... - by arvidj - 05-01-2012, 03:05 PM
RE: Cleaning Tools ... - by DaveH - 05-01-2012, 11:32 AM
RE: Cleaning Tools ... - by EdK - 05-01-2012, 04:04 PM
RE: Cleaning Tools ... - by krv3000 - 05-01-2012, 05:49 PM
RE: Cleaning Tools ... - by PixMan - 05-03-2012, 07:01 AM



Users browsing this thread: 1 Guest(s)