Bringing a Shaper into the 21st Century

Thread Modes

Bringing a Shaper into the 21st Century

f350ca Offline

Senior

Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario

The following 1 user Likes f350ca's post:
oldgoaly (08-20-2013)

#13

05-02-2013, 11:05 PM

i'd mentioned using a micrometer barrel for a depth stop somewhere here but can't find it. Anyway Rick suggested using a depth stop when cutting the rack, so here it is.

[Image: IMG_0581.jpg]

Getting closer to cutting teeth. Just a little more work on the vice to hold the rack.

Free advice is worth exactly what you payed for it.
Greg

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Bringing a Shaper into the 21st Century - by f350ca - 10-20-2012, 05:49 PM

RE: Bringing a Shaper into the 21st Century - by DaveH - 10-20-2012, 05:51 PM

RE: Bringing a Shaper into the 21st Century - by Mayhem - 10-20-2012, 07:19 PM

RE: Bringing a Shaper into the 21st Century - by sasquatch - 10-21-2012, 04:50 PM

RE: Bringing a Shaper into the 21st Century - by big job - 10-27-2012, 06:41 AM

RE: Bringing a Shaper into the 21st Century - by f350ca - 10-27-2012, 08:48 AM

RE: Bringing a Shaper into the 21st Century - by big job - 10-28-2012, 05:33 AM

RE: Bringing a Shaper into the 21st Century - by f350ca - 10-28-2012, 09:01 AM

RE: Bringing a Shaper into the 21st Century - by Rickabilly - 11-01-2012, 06:04 PM

RE: Bringing a Shaper into the 21st Century - by f350ca - 01-22-2013, 12:01 AM

RE: Bringing a Shaper into the 21st Century - by Mayhem - 01-22-2013, 08:13 AM

RE: Bringing a Shaper into the 21st Century - by f350ca - 01-23-2013, 08:35 PM

RE: Bringing a Shaper into the 21st Century - by f350ca - 05-02-2013, 11:05 PM

RE: Bringing a Shaper into the 21st Century - by Rickabilly - 08-20-2013, 09:49 AM

Users browsing this thread: 1 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me