05-02-2013, 10:04 AM
The summary of both posts was to the gist of.
Ed
On my press, I took two pieces of 1/2" x 6" FB the length of the angle iron
feet and bolted on four footmaster casters, making sure that two bolts for
each caster went through the angle iron and the other two just went through
the FB. This way I can roll the press around to where I need it and then
level it for use. I have the added benefit of raising the press up the
height of the casters, about 5" to a better working height.
Mayhem
Just be glad you are so far away from Horrible Freight as all I have ever
heard about them is horror stories, Less temptation to get junk, LOL
Walter
Ed
On my press, I took two pieces of 1/2" x 6" FB the length of the angle iron
feet and bolted on four footmaster casters, making sure that two bolts for
each caster went through the angle iron and the other two just went through
the FB. This way I can roll the press around to where I need it and then
level it for use. I have the added benefit of raising the press up the
height of the casters, about 5" to a better working height.
Mayhem
Just be glad you are so far away from Horrible Freight as all I have ever
heard about them is horror stories, Less temptation to get junk, LOL
Walter
starlight_tools, proud to be a member of Metalworking Forum since Apr 2012.