Time for a new 4-Jaw chuck - perhaps?

[EdK]

(04-28-2013, 11:43 PM)Tony Wells Wrote: Somewhere around here I made a set of transfer points like that, except I cheated. I took cone point socket set screws and screwed them into tapped holes in a scrap round and milled hexes on them so I could use small sockets to install/remove them. Yes, I know you can buy them (so?), but I had time to play.



Good job, Darren. Glad to see you replaced the other chuck. It was dangerous.

Tony,

Are the points on the set screws accurately concentric with the threads? I guess it would depend on how they are manufactured.

Ed