Shop Press

[arvidj]

(04-26-2013, 05:32 PM)EdK Wrote: I'll be picking up this shop press tomorrow and was wondering if you guys bolt your pressed down to the floor or not?

Thanks,
Ed

Mine is an wheels.

The only reason I could thing it would need to be attached to anything would be if what you put in it would cause it to tip over, like wanting to push a bushing in and out of a 10 foot bar and did not have any way of holding the far end of the bar up.

But that is such a common issue ... see cutting stuff with the horizontial band saw ... that I am sure you have some adjustable support stands floating around the shop somewhere.