Hey guys.
I'm still on target of getting a Grizzly G9972Z 11x26 Lathe this summer. I also want to replace the 4 way tool post with a QCTP. As I understand it a wedge type is preferable to the piston type (although I maybe wrong about that). Anyway I think this is the appropriate one for a lathe between 9" - 12" swing.
http://www.amazon.com/Quick-Change-Tool-...002YPDQ4G/
It even says so in the description but I'd like to get the opinion of the more experienced members on the
forum. So
A) is this correct one?
B) Is the wedge type better than the piston type?
I'm still on target of getting a Grizzly G9972Z 11x26 Lathe this summer. I also want to replace the 4 way tool post with a QCTP. As I understand it a wedge type is preferable to the piston type (although I maybe wrong about that). Anyway I think this is the appropriate one for a lathe between 9" - 12" swing.
http://www.amazon.com/Quick-Change-Tool-...002YPDQ4G/
It even says so in the description but I'd like to get the opinion of the more experienced members on the
forum. So
A) is this correct one?
B) Is the wedge type better than the piston type?
If it's crazy but it works, it's not crazy.