|
brass re-cycling !!
|
04-24-2013, 01:33 PM
Thanks Graham. Im sure its going to be a hard learning curve. Hope to get an addition / roof with no walls built across the back of the shop this summer to store and use the furnace. I also have some big, about 40 pound bronze bushings out of a seismic vibrator. Would I be best to cut them up, melt and then add some of the swarf on each pour?
Free advice is worth exactly what you payed for it.
Greg |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
brass re-cycling !! - by the artfull-codger - 04-23-2013, 04:16 PM
RE: brass re-cycling !! - by f350ca - 04-23-2013, 07:49 PM
RE: brass re-cycling !! - by the artfull-codger - 04-24-2013, 11:58 AM
RE: brass re-cycling !! - by f350ca - 04-24-2013, 01:33 PM
RE: brass re-cycling !! - by the artfull-codger - 04-24-2013, 02:26 PM
RE: brass re-cycling !! - by doubleboost - 04-24-2013, 03:50 PM
RE: brass re-cycling !! - by f350ca - 04-24-2013, 07:53 PM
RE: brass re-cycling !! - by the artfull-codger - 04-25-2013, 02:18 PM
RE: brass re-cycling !! - by doubleboost - 04-25-2013, 02:38 PM
RE: brass re-cycling !! - by the artfull-codger - 04-26-2013, 12:15 PM
RE: brass re-cycling !! - by f350ca - 04-26-2013, 12:43 PM
RE: brass re-cycling !! - by doubleboost - 04-26-2013, 02:23 PM
|
