MetalworkingFun Forum › Machining › Welding & Casting v
brass re-cycling !!

Thread Modes
brass re-cycling !!
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
#2
04-23-2013, 07:49 PM
I have a surplus of clean bronze cuttings, about 70 pounds, can they be melted down to make ingots, or is there too much surface area to oxidize? Ended up with a propane fired furnace that I need to get using.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
brass re-cycling !! - by the artfull-codger - 04-23-2013, 04:16 PM
RE: brass re-cycling !! - by f350ca - 04-23-2013, 07:49 PM
RE: brass re-cycling !! - by the artfull-codger - 04-24-2013, 11:58 AM
RE: brass re-cycling !! - by f350ca - 04-24-2013, 01:33 PM
RE: brass re-cycling !! - by the artfull-codger - 04-24-2013, 02:26 PM
RE: brass re-cycling !! - by doubleboost - 04-24-2013, 03:50 PM
RE: brass re-cycling !! - by f350ca - 04-24-2013, 07:53 PM
RE: brass re-cycling !! - by the artfull-codger - 04-25-2013, 02:18 PM
RE: brass re-cycling !! - by doubleboost - 04-25-2013, 02:38 PM
RE: brass re-cycling !! - by the artfull-codger - 04-26-2013, 12:15 PM
RE: brass re-cycling !! - by f350ca - 04-26-2013, 12:43 PM
RE: brass re-cycling !! - by doubleboost - 04-26-2013, 02:23 PM



Users browsing this thread: 4 Guest(s)