P&W 1830 Radial in 1/6 scale.

[EdK]

(04-23-2013, 05:36 PM)Bill Gruby Wrote:

(04-23-2013, 05:31 PM)EdK Wrote:

(04-23-2013, 04:09 PM)Bill Gruby Wrote: The casting needs finish work now, first the lathe , then mill, and back to the lathe. For ease of finding the center in each machine this tool was fabricated. It will also keep everything flat.

"Billy G"

I'm not sure what I'm looking at Billy but it looks impressive none the less.

Ed

Ed;
The heavy aluminum piece in the chuck is the fixture. It is made with that much mass to absorb vibration while cutting the thin casting. The casting is on a spigot and bolted in the center. This fixture will allow me to bore the offset holes for both distributors. and any other mill work. Then back into the lathe for final cuts.

"Billy G"

Billy,

OK, I took a closer look at the picture and now I see what's going on. Sorry for the

Ed