04-13-2013, 08:37 PM
Yeah, but you aren't the average bear there Yogi. ![Cool Cool](http://www.metalworkingfun.com/images/smilies/cool.gif)
I guess I should have titled it "typical" home shops.![Slaphead Slaphead](http://www.metalworkingfun.com/images/smilies/slaphead.gif)
I probably only have 3 - 4 tiny carbide end mills at most. And none of them are ball end mills which I would need for 2 of the 5 slots.
I'm sure I could buy another bit with the proper shank for probably less than what the end mills would cost. I should have known better.
![Cool Cool](http://www.metalworkingfun.com/images/smilies/cool.gif)
I guess I should have titled it "typical" home shops.
![Slaphead Slaphead](http://www.metalworkingfun.com/images/smilies/slaphead.gif)
I probably only have 3 - 4 tiny carbide end mills at most. And none of them are ball end mills which I would need for 2 of the 5 slots.
I'm sure I could buy another bit with the proper shank for probably less than what the end mills would cost. I should have known better.
![Smiley-signs140 Smiley-signs140](http://www.metalworkingfun.com/images/smilies/smiley-signs140.gif)
Willie