MetalworkingFun Forum › Machining › General Metalworking Discussion v
Head Studs

Thread Modes
Head Studs
TOM REED Offline
Junior
****
Posts: 266
Threads: 23
Joined: Feb 2012
Location: OLDS, ALBERTA
#14
04-03-2012, 06:23 PM
Just in case anyone is interested cost of complete inframe about 12,000 using quality parts from IPD, AFTER INFRAME still had an injector problem so a new set of CAT C18 marine application injectors engine now makes about 700+ HP, puts the fun back in driving for an old man hihi. tom
Logan 10x26" lathe
SIEG 12x40" lathe
RongFU 45 clone mill
6" import band saw
Baldor Grinder
thousand of tools+tooling pieces 40 yrs of collecting
Reply
Thanks given by:


Messages In This Thread
Head Studs - by TOM REED - 03-18-2012, 08:48 AM
RE: HEAD STUDS - by PixMan - 03-18-2012, 11:39 AM
RE: HEAD STUDS - by B34VD - 03-18-2012, 02:40 PM
RE: HEAD STUDS - by ETC57 - 03-18-2012, 04:30 PM
RE: HEAD STUDS - by TOM REED - 03-18-2012, 09:08 PM
RE: HEAD STUDS - by B34VD - 03-19-2012, 03:17 AM
RE: HEAD STUDS - by TOM REED - 03-19-2012, 05:22 AM
RE: HEAD STUDS - by B34VD - 03-19-2012, 07:04 AM
RE: HEAD STUDS - by TOM REED - 03-19-2012, 01:18 PM
RE: HEAD STUDS - by B34VD - 03-19-2012, 03:26 PM
RE: HEAD STUDS - by krv3000 - 03-20-2012, 09:20 AM
RE: HEAD STUDS - by aametalmaster - 03-27-2012, 06:39 PM
RE: HEAD STUDS - by TOM REED - 03-28-2012, 01:00 AM
RE: HEAD STUDS - by TOM REED - 04-03-2012, 06:23 PM
RE: HEAD STUDS - by EdK - 04-03-2012, 06:40 PM
RE: HEAD STUDS - by TOM REED - 04-04-2012, 02:14 AM
RE: HEAD STUDS - by EdK - 04-04-2012, 06:42 AM
RE: HEAD STUDS - by Highpower - 04-04-2012, 06:57 AM



Users browsing this thread: 10 Guest(s)