basic lathe tooling questions for new lathe

[doubleboost]

(04-03-2012, 02:46 PM)DaveH Wrote: Hello Bob and welcome to MetalworkingFun

My answer to Q1. I doubt if any noticeable difference in the home workshop.

My answer to Q2 & Q3. Again probably no noticeable difference, go with the most cost effective.

Questions 4 & 5 I will have to think about them

Hang about Bob, others may have a different opinion

DaveH

Hi
Bob
Unless you are pushing things to the limit you will not notice any differance with the smaller tool size
I use a piston type tool holder and i am very happy with it
As far as parting tools go this is what i use
http://www.ebay.co.uk/itm/GLANZE-CLAMP-T...46021476e0
I use the cheapest tips i can find
Mu previous lathe was fairly large (colchester Bantam).
My current lathe is much smaller so i modified my large tooling to fit , by milling a dove tail in them .
They go directly on to the tool post without a holder.



As far as tips go i would just use the most economical
There are loads of speed & feed charts on the net.
But for home work i would just experiment.
Dont forget carbide inserts like to be worked hard
John