MetalworkingFun Forum › Machining › Projects v
A normal day at the office

Thread Modes
A normal day at the office
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#4
04-08-2013, 06:26 PM
I love taperlocks! true they can cure worn shafts but if used at the out set the shafts don't wear!
I can't believe how pretty the MIGed and turned motor shaft came out! And, it didn't warp?
You're an artist John.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
A normal day at the office - by John S. - 04-08-2013, 05:27 PM
RE: A normal day at the office - by PixMan - 04-08-2013, 06:00 PM
RE: A normal day at the office - by John S. - 04-08-2013, 06:08 PM
RE: A normal day at the office - by stevec - 04-08-2013, 06:26 PM
RE: A normal day at the office - by PixMan - 04-08-2013, 06:29 PM
RE: A normal day at the office - by stevec - 04-08-2013, 06:34 PM
RE: A normal day at the office - by John S. - 04-08-2013, 06:47 PM
RE: A normal day at the office - by stevec - 04-09-2013, 07:09 AM
RE: A normal day at the office - by DaveH - 04-08-2013, 07:48 PM
RE: A normal day at the office - by sasquatch - 04-09-2013, 07:29 AM
RE: A normal day at the office - by John S. - 04-09-2013, 12:46 PM
RE: A normal day at the office - by doubleboost - 04-09-2013, 03:15 PM
RE: A normal day at the office - by John S. - 04-09-2013, 03:55 PM
RE: A normal day at the office - by Micktoon - 04-09-2013, 04:38 PM
RE: A normal day at the office - by John S. - 04-13-2013, 08:59 AM
RE: A normal day at the office - by Highpower - 04-13-2013, 11:02 AM
RE: A normal day at the office - by doubleboost - 04-13-2013, 11:10 AM
RE: A normal day at the office - by the penguin - 04-13-2013, 11:18 AM
RE: A normal day at the office - by John S. - 04-13-2013, 11:25 AM
RE: A normal day at the office - by DaveH - 04-13-2013, 02:16 PM
RE: A normal day at the office - by Mayhem - 04-14-2013, 12:27 AM
RE: A normal day at the office - by ETC57 - 04-18-2013, 09:11 PM



Users browsing this thread: 2 Guest(s)