04-07-2013, 06:22 AM
Thanks for all of the advise here.
Thanks Wrustle for the step by step instructions. You by NO means insulted my intelligence.
I think that I on the right track but had 3 things that needed 'fine tuning'
1. tool was almost square when i was trying it, but I had not taken the time to make sure that it was square.
2. I had the cutter to far out of the holder and probably allowed for flex and chatter
3. Feed speed was way to slow. started cutting and then just give it the beans.....presto
Now if the cops show up, they are going to think that I am making slugs to rip off the vending machine, since there are so many little quarter sized discs in the shop (Do vending machines even take quarters any more??)
Highpower.. thanks for the link- lots of great ideas
Now the big question...........How to remember this the next time I run into this?
More reason to practice!!
Thanks to all
Steve
Thanks Wrustle for the step by step instructions. You by NO means insulted my intelligence.
I think that I on the right track but had 3 things that needed 'fine tuning'
1. tool was almost square when i was trying it, but I had not taken the time to make sure that it was square.
2. I had the cutter to far out of the holder and probably allowed for flex and chatter
3. Feed speed was way to slow. started cutting and then just give it the beans.....presto
Now if the cops show up, they are going to think that I am making slugs to rip off the vending machine, since there are so many little quarter sized discs in the shop (Do vending machines even take quarters any more??)
Highpower.. thanks for the link- lots of great ideas
Now the big question...........How to remember this the next time I run into this?
More reason to practice!!
Thanks to all
Steve
Bustednuklz, proud to be a member of MetalworkingFun since Jun 2012.
Busting my knuckles since 1986.
Busting my knuckles since 1986.