|
Parting tool trouble
|
 (04-05-2013, 08:51 PM)DaveH Wrote: ...which one is the z axis? The z axis is defined as being parallel to the spindle. So, on a lathe, moving the saddle toward or away from the chuck is moving along the z axis. So, locking the z axis will reduce the risk of the tool flexing whilst in the cut.
Hunting American dentists since 2015.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Parting tool trouble - by Bustednuklz - 04-05-2013, 07:54 PM
RE: Parting tool trouble - by EdK - 04-05-2013, 08:02 PM
RE: Parting tool trouble - by Bustednuklz - 04-05-2013, 08:10 PM
RE: Parting tool trouble - by Mayhem - 04-05-2013, 08:20 PM
RE: Parting tool trouble - by DaveH - 04-05-2013, 08:51 PM
RE: Parting tool trouble - by EdK - 04-05-2013, 08:20 PM
RE: Parting tool trouble - by DaveH - 04-05-2013, 08:33 PM
RE: Parting tool trouble - by f350ca - 04-05-2013, 08:56 PM
RE: Parting tool trouble - by Hopefuldave - 04-05-2013, 09:02 PM
RE: Parting tool trouble - by Mayhem - 04-05-2013, 09:13 PM
RE: Parting tool trouble - by Bustednuklz - 04-05-2013, 09:49 PM
RE: Parting tool trouble - by wrustle - 04-06-2013, 07:24 AM
RE: Parting tool trouble - by Mayhem - 04-06-2013, 10:22 AM
RE: Parting tool trouble - by Highpower - 04-06-2013, 10:43 AM
RE: Parting tool trouble - by Bustednuklz - 04-07-2013, 06:22 AM
RE: Parting tool trouble - by Mayhem - 04-07-2013, 06:32 AM
RE: Parting tool trouble - by DaveH - 04-07-2013, 10:14 AM
RE: Parting tool trouble - by DaveH - 04-07-2013, 10:17 AM
RE: Parting tool trouble - by Ozwelder - 05-09-2013, 06:11 AM
|
