04-05-2013, 08:33 PM
Steve,
Sometimes a picture of your set up may help.
Something to try: your cutter is 1.5mm wide, so push the ali bar in to the chuck so only 20-30mm is sticking out. Then cut (as you would in parting off) 0.75mm off the end of the ali bar. So you are only using half the width of the cutter.
DaveH
Sometimes a picture of your set up may help.
Something to try: your cutter is 1.5mm wide, so push the ali bar in to the chuck so only 20-30mm is sticking out. Then cut (as you would in parting off) 0.75mm off the end of the ali bar. So you are only using half the width of the cutter.
DaveH