|
Parting tool trouble
|
04-05-2013, 08:20 PM
Are you locking the z axis?
Generally you increase the feed when the tool begins to complain. However, it sounds like you are stalling the lathe when you do this. Belts tight?
Hunting American dentists since 2015.
Thanks given by: Bustednuklz
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Parting tool trouble - by Bustednuklz - 04-05-2013, 07:54 PM
RE: Parting tool trouble - by EdK - 04-05-2013, 08:02 PM
RE: Parting tool trouble - by Bustednuklz - 04-05-2013, 08:10 PM
RE: Parting tool trouble - by Mayhem - 04-05-2013, 08:20 PM
RE: Parting tool trouble - by DaveH - 04-05-2013, 08:51 PM
RE: Parting tool trouble - by EdK - 04-05-2013, 08:20 PM
RE: Parting tool trouble - by DaveH - 04-05-2013, 08:33 PM
RE: Parting tool trouble - by f350ca - 04-05-2013, 08:56 PM
RE: Parting tool trouble - by Hopefuldave - 04-05-2013, 09:02 PM
RE: Parting tool trouble - by Mayhem - 04-05-2013, 09:13 PM
RE: Parting tool trouble - by Bustednuklz - 04-05-2013, 09:49 PM
RE: Parting tool trouble - by wrustle - 04-06-2013, 07:24 AM
RE: Parting tool trouble - by Mayhem - 04-06-2013, 10:22 AM
RE: Parting tool trouble - by Highpower - 04-06-2013, 10:43 AM
RE: Parting tool trouble - by Bustednuklz - 04-07-2013, 06:22 AM
RE: Parting tool trouble - by Mayhem - 04-07-2013, 06:32 AM
RE: Parting tool trouble - by DaveH - 04-07-2013, 10:14 AM
RE: Parting tool trouble - by DaveH - 04-07-2013, 10:17 AM
RE: Parting tool trouble - by Ozwelder - 05-09-2013, 06:11 AM
|
