MetalworkingFun Forum › Machining › General Metalworking Discussion v
Parting tool trouble

Thread Modes
Parting tool trouble
Bustednuklz Offline
Freshman
**
Posts: 11
Threads: 3
Joined: Jun 2012
Location: Canada
#3
04-05-2013, 08:10 PM
Hi Ed
I thought I had covered it all...... But ......
Yes I have tried using WD40 (by the gallon) and kerosene minimally.
The WD40 seemed to help a little, but still enough chatter to shut the lathe down

Thanks again
Steve
Bustednuklz, proud to be a member of MetalworkingFun since Jun 2012.
Busting my knuckles since 1986.
Reply
Thanks given by:


Messages In This Thread
Parting tool trouble - by Bustednuklz - 04-05-2013, 07:54 PM
RE: Parting tool trouble - by EdK - 04-05-2013, 08:02 PM
RE: Parting tool trouble - by Bustednuklz - 04-05-2013, 08:10 PM
RE: Parting tool trouble - by Mayhem - 04-05-2013, 08:20 PM
RE: Parting tool trouble - by DaveH - 04-05-2013, 08:51 PM
RE: Parting tool trouble - by EdK - 04-05-2013, 08:20 PM
RE: Parting tool trouble - by DaveH - 04-05-2013, 08:33 PM
RE: Parting tool trouble - by f350ca - 04-05-2013, 08:56 PM
RE: Parting tool trouble - by Hopefuldave - 04-05-2013, 09:02 PM
RE: Parting tool trouble - by Mayhem - 04-05-2013, 09:13 PM
RE: Parting tool trouble - by Bustednuklz - 04-05-2013, 09:49 PM
RE: Parting tool trouble - by wrustle - 04-06-2013, 07:24 AM
RE: Parting tool trouble - by Mayhem - 04-06-2013, 10:22 AM
RE: Parting tool trouble - by Highpower - 04-06-2013, 10:43 AM
RE: Parting tool trouble - by Bustednuklz - 04-07-2013, 06:22 AM
RE: Parting tool trouble - by Mayhem - 04-07-2013, 06:32 AM
RE: Parting tool trouble - by DaveH - 04-07-2013, 10:14 AM
RE: Parting tool trouble - by DaveH - 04-07-2013, 10:17 AM
RE: Parting tool trouble - by Ozwelder - 05-09-2013, 06:11 AM



Users browsing this thread: 7 Guest(s)