04-05-2013, 06:28 PM
(04-05-2013, 06:21 PM)stevec Wrote: Ed, I meant an intended dimple like a touch with a drill or ball end mill would produce so that the gib would be forced against the dovetail instead of forcing the gib upwards due to the angle.
Not to worry, it seems you have more pressing maters to attend to.
Oops! Sorry Steve. I misunderstood your question.
I don't think there's a designed in dimple. The dimple would move when you adjusted the gibs so it wouldn't make a lot of sense to design one in.
Good question though. I'll check when I take the table apart.
Ed