MetalworkingFun Forum › Machinery › Lathes v
Cross slide lock with a DRO fitted

Thread Modes
Cross slide lock with a DRO fitted
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#6
04-05-2013, 09:38 AM
(04-05-2013, 09:21 AM)Dave J Wrote: ...I slipped in a bearing while I was there like I did to the mill when I got it. It make locking an axis so much easier with a bearing between the bolt and the tapered slug in the lock hole...

Dave - can you elaborate on this please? Are you using a thrust bearing?
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Cross slide lock with a DRO fitted - by Dave J - 04-05-2013, 05:44 AM
RE: Cross slide lock with a DRO fitted - by DaveH - 04-05-2013, 07:54 AM
RE: Cross slide lock with a DRO fitted - by EdK - 04-05-2013, 08:23 AM
RE: Cross slide lock with a DRO fitted - by Mayhem - 04-05-2013, 09:38 AM
RE: Cross slide lock with a DRO fitted - by EdK - 04-05-2013, 11:50 AM
RE: Cross slide lock with a DRO fitted - by DaveH - 04-05-2013, 01:01 PM
RE: Cross slide lock with a DRO fitted - by EdK - 04-05-2013, 02:23 PM
RE: Cross slide lock with a DRO fitted - by EdK - 04-05-2013, 04:07 PM
RE: Cross slide lock with a DRO fitted - by EdK - 04-05-2013, 06:28 PM
RE: Cross slide lock with a DRO fitted - by DaveH - 04-05-2013, 07:34 PM
RE: Cross slide lock with a DRO fitted - by EdK - 04-05-2013, 07:59 PM



Users browsing this thread: 1 Guest(s)