Help - Machining slim rod on the lathe
#31
Wong,

If you are having trouble with breaking taps now is not the time to try power tapping, especially with an M2. Like Greg, I power tap all the time, but I've been doing it for years. If you want to experiment with power tapping, an M12 would be a good place to start.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
RE: Help - Machining slim rod on the lathe - by TomG - 04-04-2013, 04:32 PM



Users browsing this thread: 1 Guest(s)