04-04-2013, 03:10 PM
Hello Guys
Here I am back after a long time. The last three months we have completely renovated the bathroom and my garage so I had little time in my workshop to work on my shaper. On the pictures you can see I need to paint still the walls. I did not quite sit still and have the gearbox now fully ready. I was a little afraid to make the gearbox. I had no drawings or pictures so I had to draw and calculate everything from scatch. The gearbox works perfectly. The gear shifters work very smooth. I am very happy that everything went well. I also have made the base plate and the stand. Attached some pictures.
Gearbox in high speed position
Gearbox in low speed position
lower gear shifter
Machine stand
Base plate with in the middle the two holes for the table lift mechanism.
Here I am back after a long time. The last three months we have completely renovated the bathroom and my garage so I had little time in my workshop to work on my shaper. On the pictures you can see I need to paint still the walls. I did not quite sit still and have the gearbox now fully ready. I was a little afraid to make the gearbox. I had no drawings or pictures so I had to draw and calculate everything from scatch. The gearbox works perfectly. The gear shifters work very smooth. I am very happy that everything went well. I also have made the base plate and the stand. Attached some pictures.
Gearbox in high speed position
Gearbox in low speed position
lower gear shifter
Machine stand
Base plate with in the middle the two holes for the table lift mechanism.