|
Tool Gloat
|
04-03-2013, 11:43 AM
My impression is that the wider slot would mean less contact/support for the small diameter piece yet the wide portion is still necessary to permit the flex without having to tighten the smaller size collets more than the larger ones.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Tool Gloat - by Mayhem - 03-29-2013, 02:12 AM
RE: Tool Gloat - by TomG - 03-29-2013, 06:59 AM
RE: Tool Gloat - by sasquatch - 03-29-2013, 07:41 AM
RE: Tool Gloat - by EdK - 03-29-2013, 09:51 AM
RE: Tool Gloat - by Mayhem - 03-29-2013, 09:02 PM
RE: Tool Gloat - by Mayhem - 04-03-2013, 03:33 AM
RE: Tool Gloat - by EdK - 04-03-2013, 05:50 AM
RE: Tool Gloat - by TomG - 04-03-2013, 06:22 AM
RE: Tool Gloat - by Mayhem - 04-03-2013, 06:42 AM
RE: Tool Gloat - by EdK - 04-03-2013, 06:49 AM
RE: Tool Gloat - by Mayhem - 04-03-2013, 06:55 AM
RE: Tool Gloat - by DaveH - 04-03-2013, 09:38 AM
RE: Tool Gloat - by Mayhem - 04-03-2013, 09:41 AM
RE: Tool Gloat - by stevec - 04-03-2013, 11:43 AM
RE: Tool Gloat - by sasquatch - 04-03-2013, 03:16 PM
|
