MetalworkingFun Forum › Machining › General Metalworking Discussion v
Tool Gloat

Thread Modes
Tool Gloat
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#7
04-03-2013, 05:50 AM
(04-03-2013, 03:33 AM)Mayhem Wrote: ... I did notice that the slits on the 1-2mm collet are cut a little different (thickness of the slit) but I'm unsure if this will make any difference.

Darren,

Maybe it has something to do with the smaller collets having 6 slits while the 20mm has 8. Chin

Ed
Reply
Thanks given by:


Messages In This Thread
Tool Gloat - by Mayhem - 03-29-2013, 02:12 AM
RE: Tool Gloat - by TomG - 03-29-2013, 06:59 AM
RE: Tool Gloat - by sasquatch - 03-29-2013, 07:41 AM
RE: Tool Gloat - by EdK - 03-29-2013, 09:51 AM
RE: Tool Gloat - by Mayhem - 03-29-2013, 09:02 PM
RE: Tool Gloat - by Mayhem - 04-03-2013, 03:33 AM
RE: Tool Gloat - by EdK - 04-03-2013, 05:50 AM
RE: Tool Gloat - by TomG - 04-03-2013, 06:22 AM
RE: Tool Gloat - by Mayhem - 04-03-2013, 06:42 AM
RE: Tool Gloat - by EdK - 04-03-2013, 06:49 AM
RE: Tool Gloat - by Mayhem - 04-03-2013, 06:55 AM
RE: Tool Gloat - by DaveH - 04-03-2013, 09:38 AM
RE: Tool Gloat - by Mayhem - 04-03-2013, 09:41 AM
RE: Tool Gloat - by stevec - 04-03-2013, 11:43 AM
RE: Tool Gloat - by sasquatch - 04-03-2013, 03:16 PM



Users browsing this thread: 1 Guest(s)