Hard Soldering Steel

Thread Modes

Hard Soldering Steel

EdK

Whipping Boy

Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota

#10

04-02-2013, 05:38 PM

(04-02-2013, 05:26 PM)f350ca Wrote: Should work Ed, make sure its clean like Dallen said, but don't use brake cleaner, some of that stuff can give off nasty fumes when heated.

I was reading about hard soldering and the article said to use acetone to clean the parts off. Is it OK to use the silver solder that's sold for soldering copper pipe? I'm assuming I'll need some flux made for steel though rather than copper.

Ed

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Hard Soldering Steel - by EdK - 04-02-2013, 09:26 AM

RE: Hard Soldering Steel - by f350ca - 04-02-2013, 12:08 PM

RE: Hard Soldering Steel - by EdK - 04-02-2013, 12:17 PM

RE: Hard Soldering Steel - by f350ca - 04-02-2013, 12:45 PM

RE: Hard Soldering Steel - by EdK - 04-02-2013, 01:04 PM

RE: Hard Soldering Steel - by f350ca - 04-02-2013, 01:14 PM

RE: Hard Soldering Steel - by EdK - 04-02-2013, 01:47 PM

RE: Hard Soldering Steel - by dallen - 04-02-2013, 03:48 PM

RE: Hard Soldering Steel - by f350ca - 04-02-2013, 05:26 PM