04-02-2013, 04:18 PM
You guys are right. I'll hold out for a proper shop press. I measured the CRV and I could just fit the 20 ton in. There's plenty of width and just barely enough length.
Does anyone know if the 12 ton would be adequate for a home shop or would I be better off getting the 20 ton? I know it depends a lot on what you work on but for normal metalworking home shops is the 12 ton adequate? I don't work on autos at all so it would be just for the metalworking hobby.
Ed
Does anyone know if the 12 ton would be adequate for a home shop or would I be better off getting the 20 ton? I know it depends a lot on what you work on but for normal metalworking home shops is the 12 ton adequate? I don't work on autos at all so it would be just for the metalworking hobby.
Ed