04-02-2013, 03:48 PM
ED
make sure you clean the parts well to remove all the oil, coat all surfaces with flux, cut a hunk of solder off large enough for the joint and place it in the solder then heat till solder melts and runs into the joint.
DAllen
make sure you clean the parts well to remove all the oil, coat all surfaces with flux, cut a hunk of solder off large enough for the joint and place it in the solder then heat till solder melts and runs into the joint.
DAllen
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!