Hard Soldering Steel
#7
(04-02-2013, 01:14 PM)f350ca Wrote: There's not much length on the connection, I'd be tempted to go with you original method of soldering it.

I wondered about that. Oh well, I'll try hard soldering it and see what happens. I had planned on making the lever out of 1018 CRS and the shaft out of O-1 drill rod. Will those two solder together without a problem?

Thanks,
Ed
Reply
Thanks given by:


Messages In This Thread
Hard Soldering Steel - by EdK - 04-02-2013, 09:26 AM
RE: Hard Soldering Steel - by f350ca - 04-02-2013, 12:08 PM
RE: Hard Soldering Steel - by EdK - 04-02-2013, 12:17 PM
RE: Hard Soldering Steel - by f350ca - 04-02-2013, 12:45 PM
RE: Hard Soldering Steel - by EdK - 04-02-2013, 01:04 PM
RE: Hard Soldering Steel - by f350ca - 04-02-2013, 01:14 PM
RE: Hard Soldering Steel - by EdK - 04-02-2013, 01:47 PM
RE: Hard Soldering Steel - by dallen - 04-02-2013, 03:48 PM
RE: Hard Soldering Steel - by f350ca - 04-02-2013, 05:26 PM
RE: Hard Soldering Steel - by EdK - 04-02-2013, 05:38 PM
RE: Hard Soldering Steel - by f350ca - 04-02-2013, 06:17 PM
RE: Hard Soldering Steel - by EdK - 04-02-2013, 07:40 PM
RE: Hard Soldering Steel - by f350ca - 04-02-2013, 08:38 PM
RE: Hard Soldering Steel - by Tony Wells - 04-03-2013, 12:49 AM
RE: Hard Soldering Steel - by Hawkeye - 04-03-2013, 08:48 PM



Users browsing this thread: 3 Guest(s)