|
Holding small work pieces
|
|
04-01-2012, 09:23 PM
I have had good luck when profiling out small parts from 416ss sheet using a 3/32" end mill to glue them down with locktite product called blackmax onto a scrap chunk of metal. It is pretty shock resistant stuff. To get apart it works to soak in acetone overnight or take a torch to them. Here is a link to blackmax at mcmaster: http://www.mcmaster.com/#loctite-black-m...es/=gx9f33
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Holding small work pieces - by DaveH - 03-08-2012, 02:38 PM
RE: Holding small work pieces - by EdK - 03-08-2012, 04:48 PM
RE: Holding small work pieces - by B34VD - 03-11-2012, 05:51 PM
RE: Holding small work pieces - by Bogstandard - 03-30-2012, 02:08 AM
RE: Holding small work pieces - by EdK - 03-30-2012, 07:10 AM
RE: Holding small work pieces - by DaveH - 03-30-2012, 08:57 PM
RE: Holding small work pieces - by Highpower - 03-30-2012, 10:11 PM
RE: Holding small work pieces - by EdK - 03-30-2012, 10:14 PM
RE: Holding small work pieces - by Highpower - 03-30-2012, 10:32 PM
RE: Holding small work pieces - by EdK - 03-31-2012, 08:39 AM
RE: Holding small work pieces - by Wongster - 03-30-2012, 11:03 PM
RE: Holding small work pieces - by DaveH - 03-31-2012, 10:17 AM
RE: Holding small work pieces - by Highpower - 04-01-2012, 11:56 AM
RE: Holding small work pieces - by Wongster - 03-31-2012, 10:47 PM
RE: Holding small work pieces - by DaveH - 04-01-2012, 02:45 AM
RE: Holding small work pieces - by ToolCat - 04-01-2012, 09:23 PM
RE: Holding small work pieces - by DaveH - 04-01-2012, 11:24 PM
RE: Holding small work pieces - by krv3000 - 04-02-2012, 02:16 AM
|
