03-27-2013, 05:33 PM
Tom,
Thanks for the tip about cutting steel threads by advancing the compound versus cutting Delrin threads using the cross slide. I did not know that about Delrin but it makes good sense.![Thumbsup Thumbsup](http://www.metalworkingfun.com/images/smilies/thumbsup.gif)
Ed
Thanks for the tip about cutting steel threads by advancing the compound versus cutting Delrin threads using the cross slide. I did not know that about Delrin but it makes good sense.
![Thumbsup Thumbsup](http://www.metalworkingfun.com/images/smilies/thumbsup.gif)
Ed