03-23-2013, 06:19 PM
Greg, there were threaded mounting holes on the engine and the flywheel had a ring gear. I found a brand new starter on Fleabay at a good price and reasonable shipping, all I had to do was bend it's mounting feet a bit to get good engagement with the ring gear.
The carb was new off of Fleabay too, from a Cdn. vendor so it only cost Canada Post rip off plus the vendors charge. Once assemble and fed with gas the little bugger started up immediately!
The carb was new off of Fleabay too, from a Cdn. vendor so it only cost Canada Post rip off plus the vendors charge. Once assemble and fed with gas the little bugger started up immediately!
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.