How to slow down power feed?

[Wongster]

Dave,

I've only 3 belt positions with 2 speed each:
Position 1: 80 - 160 rpm
Position 2: 330 - 660 rpm
Position 3: 1400 - 2800 rpm

Now I wish for those variable speed type motor like what I've on the sherline...

This is the cutting oil I'm using, recommended by the shop I bought my tools from locally:





I'm now left with about 3.7mm in diameter to go. Finish has improved with the radius tip carbide insert tool at 0.1mm per pass. Except for the 0.02mm difference in diameter in the length of about 15mm (spindle end bigger), I'm rather satisfied with what I've so far (I've lowered my expectation for now).



You can see from the pic above that I'll have to reset my tool angle again to continue my cut for the last 3 odd mm. Will be looking out for live centre with longer nose.

Have to stop work as I'll be up earlier tomorrow for work.

Regards,
Wong