MetalworkingFun Forum › Machining › General Metalworking Discussion v
What insert type is this?

Thread Modes
What insert type is this?
Kaoma Offline
Freshman
**
Posts: 23
Threads: 6
Joined: Apr 2012
Location: Arizona
#5
03-21-2013, 09:16 PM
Just checked and the caliper is calibrated, the insert is chipped on all sides...It is installed (was) on a 1/2" sq. tool holder as seen in the picture. All sides are equal with the same rake angle.
Kaoma, proud to be a member of MetalworkingFun Forum since Apr 2012.
Reply
Thanks given by:


Messages In This Thread
What insert type is this? - by Kaoma - 03-21-2013, 01:12 AM
RE: What insert type is this? - by EdK - 03-21-2013, 06:03 AM
RE: What insert type is this? - by stevec - 03-21-2013, 06:14 AM
RE: What insert type is this? - by PixMan - 03-21-2013, 06:47 AM
RE: What insert type is this? - by Kaoma - 03-21-2013, 09:16 PM
RE: What insert type is this? - by the penguin - 03-21-2013, 09:34 PM
RE: What insert type is this? - by PixMan - 03-21-2013, 09:50 PM
RE: What insert type is this? - by the penguin - 03-21-2013, 09:54 PM
RE: What insert type is this? - by Kaoma - 03-21-2013, 10:08 PM
RE: What insert type is this? - by Kaoma - 03-21-2013, 10:36 PM
RE: What insert type is this? - by PixMan - 03-21-2013, 10:38 PM
RE: What insert type is this? - by Mayhem - 03-22-2013, 08:49 AM



Users browsing this thread: 1 Guest(s)