MetalworkingFun Forum › Machining › General Metalworking Discussion v
Holding small work pieces

Thread Modes
Holding small work pieces
Wongster Offline
Junior
****
Posts: 301
Threads: 30
Joined: Mar 2012
Location: Singapore
#13
03-31-2012, 10:47 PM
Dave,

This is the standard sherline vise I'm using:

[Image: 37f67fe8.jpg]

This is the Matchling, made in Taiwan and opens about 25mm more than the Sherline's:

[Image: 5414dbc0.jpg]
Wongster
http://www.wongstersproduction.com

Proud to be a member of MetalworkingFun Forum since Mar 2012.
Reply
Thanks given by:


Messages In This Thread
Holding small work pieces - by DaveH - 03-08-2012, 02:38 PM
RE: Holding small work pieces - by EdK - 03-08-2012, 04:48 PM
RE: Holding small work pieces - by B34VD - 03-11-2012, 05:51 PM
RE: Holding small work pieces - by Bogstandard - 03-30-2012, 02:08 AM
RE: Holding small work pieces - by EdK - 03-30-2012, 07:10 AM
RE: Holding small work pieces - by DaveH - 03-30-2012, 08:57 PM
RE: Holding small work pieces - by Highpower - 03-30-2012, 10:11 PM
RE: Holding small work pieces - by EdK - 03-30-2012, 10:14 PM
RE: Holding small work pieces - by Highpower - 03-30-2012, 10:32 PM
RE: Holding small work pieces - by EdK - 03-31-2012, 08:39 AM
RE: Holding small work pieces - by Wongster - 03-30-2012, 11:03 PM
RE: Holding small work pieces - by DaveH - 03-31-2012, 10:17 AM
RE: Holding small work pieces - by Highpower - 04-01-2012, 11:56 AM
RE: Holding small work pieces - by Wongster - 03-31-2012, 10:47 PM
RE: Holding small work pieces - by DaveH - 04-01-2012, 02:45 AM
RE: Holding small work pieces - by ToolCat - 04-01-2012, 09:23 PM
RE: Holding small work pieces - by DaveH - 04-01-2012, 11:24 PM
RE: Holding small work pieces - by krv3000 - 04-02-2012, 02:16 AM



Users browsing this thread: 8 Guest(s)