Metal gears for 7x12s

[EdK]

(03-17-2013, 06:52 AM)stevec Wrote: For what it's worth, jmo. When I converted my 12 x 37 belt drive lathe to gear head I used stock gears (I think "MartinSprocket" were the cheapest). I cut my own gears from Delrin plastic so that each gear mating would be from metal to plastic or plastic to metal. The reasoning was economy and lubricity. Converting the headstock to a leakproof sump would have been impossible.
This was done almost 20 years ago and I have not had a failure yet.
About 8 years ago I replaced the 1½ hp original motor with a 3 hp motor (from "inventory") and haven't "stressed" the gears further.
The primary drive is via single "B" section belt so there's a "torque limiting" factor there.

There has been some lubricant applied so it's hard to tell the plastic ones from the steel.

Wow, nice modification Steve!
You're right, I can't tell which ones are the Delrin ones.

Ed