03-15-2013, 10:03 PM
here's a link to stock drive products which is were I would them from you may have to pay more, but you will get a lot higher quality of gear.
http://www.sdp-si.com/eStore/CoverPg/Gears.htm
I have one of the HF 7X12 lathes which I changed the plastic gears in the head to metal ones because I had them from when my mini mill was gear driven.
actually any place that you can buy Module 1 gears from will have the gears you need to swap.
DA
http://www.sdp-si.com/eStore/CoverPg/Gears.htm
I have one of the HF 7X12 lathes which I changed the plastic gears in the head to metal ones because I had them from when my mini mill was gear driven.
actually any place that you can buy Module 1 gears from will have the gears you need to swap.
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!